Filter Results By:
Products
Applications
Manufacturers
-
product
Roundness & Form Measuring Instruments
Taylor Hobson offers a world leading range surface form, surface finish and metrology solutions for 3D contour,ideal for the most demanding applications.
-
product
Sensor for Filament Inspection
EyeFI
EVT presents the EyeFI - the sensor for the inspection of filaments. The sensor contains two cameras with an Aptina sensor and S-Mount lenses. The cameras are perpendicular to each other. It is therefore possible to inspect two sides of the filament, which means that the EyeFI can detect if the filament is out-of-roundness. Additionally the errors and defects can be detected. For example the occurring flaws are point-shaped or partly flaked, or point-shaped and transverse, or also looking like a longitudial rib, or only spots in different shapes. The defects can be detected with the EyeFI sensor. The EyeFI contains board cameras with sensors from Aptina, the IoCap and an evaluation processor. The housing is about 14x10x4 cm in size. The IoCap is the image-capture-IO-board, which is designed and developped by EVT.
-
product
Measuring Devices For Drawing Rings And Punches For 2-part Can Production
RINGMASTER - The Benchmark For Accuracy
Optik Elektronik Gerätetechnik GmbH
High-precision, non-contact measurement of inside and outside diameter, roundness (inside and outside) and concentricity of drawing rings for 2-piece can production. The Ringmaster sets standards in measuring accuracy, user friendliness and reliability and is therefore used in can factories on all continents.
-
product
Measuring Devices For Drawing Dies And Punches For 2-piece Can Production
PUNCHMASTER - the benchmark for accuracy
Optik Elektronik Gerätetechnik GmbH
Measurement of the outer diameter, the roundness and the outer contour of cylinders, in particular of punches (stamps) for the 2-part beverage can production.
-
product
Drawing Die And Wire Measurement
Wire Diameter And Roundness Measurement
Optik Elektronik Gerätetechnik GmbH
The DGMS is a measuring system for diameter and roundness of wires, drawing dies and enameling dies. The wire diameter is measured highly accurate by an image processing system. To measure the roundness, an additional special holder is necessary to rotate the wire for the diameter measurement in several azimuths. The accuracy of the measurement is ‹1micron.
-
product
Drawing Die And Wire Measurement
DGMS – Die Geometry Measuring System
Optik Elektronik Gerätetechnik GmbH
Measuring system for diameter, roundness, reduction angle and bearing length of wire drawing dies.
-
product
Personal Workstations for Load Ranges up to 440 lbs.
9200 Series
The 9200 Series Vibration Isolation Workstation is a smaller, more compact design providing affordable personal convenience. The 9200 is ideal for applications such as Balances, Optical Microscopes, Cell Injection, Roundness Checkers, and Surface Profilometers.
-
product
Waviness, Roundness and Form Analyser
SKF Condition Monitoring Center
Waviness testers from SKF allow analysis of the waviness on the components and thus give the production engineer a powerful tool to improve the production process. Because low noise and vibration of bearings is becoming more important, there is a high demand on the measuring accuracy and resolution.
-
product
Roundness And Cylindrical Profile Measuring Instruments
We respond to a variety of needs with our lineup including both rotating table types that enable high precision measurement of cylindrical workpieces, and rotating type detectors that handle eccentric or heavy workpieces.
