Filter Results By:
Products
Applications
Manufacturers
-
product
Ferroresonant Power Supplies
Series PRM
These units are modular ferroresonant MIL-STD-461-compliant voltage stabilizers which obtain their source-isolated, overload-protected output from Kepco's proprietary transformer, Flux-O-Tran. This design lends itself to custom volt-ampere combinations, consult factory.
-
product
Linear Bench or Rack Mount Power Supplies Programmable, Local or Digital Control, Ultra Low Ripple/Noise
Series PCX-MAT
These voltage stabilizers with a full complement of meters and controls, are 1/6-rack size units designed to plug directly into their own carrier cases and rack adapters. Seven models are available. These power supplies offer ultra low noise and ultra low ripple at the output and are MIL-STD-461 compliant. A modular version of PCX-MAT called PCX is also available. Contact Kepco for details.
-
product
Linear Bench Power Supplies Local Control, Ultra Low Ripple/Noise
Series MSK
Kepco's MSK linear power supplies provide a selection of five models, offering 100 Watts of stable benchtop power. They use a high gain linear (series pass) stabilizer circuit for ultra low noise and low ripple output, good stability, and accurate resettability, and they are MIL-STD-461 compliant.MSK's "Preview" switch (d-c on-off) allows voltage and current to be pre-set with the digital meters displaying the set values. At "d-c off," no voltage is applied to the output terminals and no load current needs to be drawn to set the current limit. At "d-c on," the set voltage is applied to the output terminals, the appropriate mode indicator illuminates and the meters indicate actual voltage and current.
-
product
Linear Power Supplies High Voltage, Analog, Digital or Local Control, Ultra Low Ripple/Noise
Series BHK-MG
Kepco's BHK-MG are high voltage, linear, voltage-current stabilizers with rectangular (automatic crossover) output characteristic and ultra low noise and ultra low ripple at the output. All models are MIL-STD-461 compliant. They are offered in two sizes: a 40 watt half-rack design and a 200 watt full-rack power supply. The four models in each size have outputs of 0-300 volts, 0-500 volts, 0-1000 volts and 0-2000 volts. Both digital and analog programming control is featured.
-
product
Linear Power Supplies Voltage Stabilizer/Current Limiting, Ultra Low Ripple/Noise
Series JQE
Series JQE power supplies are systems-type voltage stabilizers with current limiting. They are available in a variety of ratings: 100 watts in a 1/4-rack package, 250-500 watts in a 1/2-rack package, and 1000 watts in a full-rack package. These power supplies offer ultra low noise and ultra low ripple at the output. They are MIL-STD-461 compliant.The traditional analog meters (M Models) have been replaced by digital meters on DM models. Availability of models with analog meters is limited and they will be discontinued in the future.
-
product
Linear Rack Mount Power Supplies Current Stabilizers, Programmable, Local/Digital/Analog Control, Ultra Low Ripple/Noise
Series CC
These current stabilizers with built-in, dual range current-sensing resistors and a full complement of meters and controls, are 1/6-rack size units designed to plug directly into their own carrier cases and rack adapters. These power supplies offer ultra low noise and ultra low ripple at the output and are MIL-STD-461 compliant.
-
product
Power Stabilizers
Manufacturer of a wide range of products which include 100 KVA Power Stabilizer, Three Phase Power Stabilizer, Electric Power Stabilizer, Industrial Portable Stabilizer, 50 KVA Power Stabilizer and 100 Kva Power Stabilizer.
-
product
Servo Stabilizers
We are a leading Manufacturer of Single Phase Servo Voltage Stabilizer, 3 Phase Air Cooled Voltage Servo Stabilizer and Oil Cooled Servo Stabilizer from Vadodara, India.
-
product
Automatic Crossover, 1U High, 2400-Watt Voltage/Current Stabilizers
Series KLR
The KLR Power Supply Series are automatic crossover, 1U high, 2400-watt voltage/current stabilizers with a full rectangular output characteristic within the voltage and current ranges listed in the Models Table.For each model a multitude of limit models can be configured. Limit models allow the unit to be configured to maximum settings below the rated voltage and/or rated current. When a limit model is established the unit will not accept programming values above the user-defined limits.The standard KLR Models (no suffix) have built-in GPIB and RS 232 interfaces. The E-Series models (suffix E) have built-in GPIB and LAN interfaces. The LAN interface is an ethernet-based interface that allows multiple-user access via a standard web browser.
-
product
Phase Modulated Driver
The Phase Modulation Capable RF Driver / Stabilizer is an eight channel, two phase RF driver intended to drive devices such as the Harris H-401. The driver provides both amplitude and phase modulation capabilities in a single unit. The device can be operated in driver mode where the operator has full control over amplitude, frequency, and phase, or in stabilizer mode where the driver automatically adjusts the operating parameters based on optical feedback from an optical pick-off point.
-
product
Spinstand Automation for Media Testing
V2002
The spinstand V2002 with the media-testing automation loads and unloads the cap of the vacuum chuck1 and moves the disk stabilizer shroud on and off media without operator’s intervention. As a result, less time is required for a media replacement, so the same number of disks can be tested faster.
-
product
Aerospace Cylinders And Actuators
Parker's Aerospace actuator and cylinder selection comprises hydraulic, pneumatic, and electromechanical actuators and cylinders. It offers industrial cylinders and linear, electrohydraulic, and electrohydrostatic actuators, including devices such as hydraulic servoactuators, flight-control, mechanical-input, stabilizer, variable-bypass, vane, and thrust-reverser actuators or actuation systems.
-
product
Automated OIS Tests
STEVE-6D
Image Engineering GmbH & Co. KG
STEVE executes controlled movements and delivers results about the performance of a camera's image stabilizer. The included control software includes an automated analysis and can also operate the Digitus, a device for automated triggering of a camera.
-
product
Polarization Stabilizer, 2 Port
POS-202
The POS-202 has optical ports for signal input and output. It stabilizes the output SOP to linear, aligned to the slow axis of the output PM fiber.
-
product
Polarization Stabilizer, 3 Port
POS-203
The POS-203 has optical ports for signal input and output and a third port for an optical feedback signal. It automatically optimizes the output SOP to either maximize or minimize and optical or electrical feedback signal. It also allows the operator to control the step size, feedback delay, activation threshold, and search algorithm (maximum or minimum) from the front panel as well as remotely via one of the digital interfaces.
-
product
Voltage Stabilizer
MS 7643
VSTAB is a voltage stabilizer, regulates the incoming supply +28V voltage into the required +15V. The electrical specifications meets MIL704 standard. Over load and short circuit protections are provided. Voltage stabilizer Module is a part of shipborne unit and it is meant for ensuring the power supply of the devices of this unit when fed from DC mains with nominal voltage of 28 V and variations of voltages from minimum 16V to maximum 32 V. The power consumption is 45 watts. The module is subjected to Qualification Tests as per MIL-STD-810G.
-
product
Aluminum Cabinet Stabilizers, Pair
ST-1
Cabinet stabilizers are cast aluminum construction. They extend 10” (254mm) from the base and are adjustable with leveling screw/pads.
-
product
Gyroscopes
A device consisting of a wheel or disk mounted so that it can spin rapidly about an axis that is itself free to alter in direction. The orientation of the axis is not affected by tilting of the mounting; so gyroscopes can be used to provide stability or maintain a reference direction in navigation systems, automatic pilots, and stabilizers.
