- TEAM SOLUTIONS, INC.
product
Single Rear Slot Universal Low-Profile PCI to Compact Flash Adapter
P312
To cater for the latest generation of Low Profile PCs that can only use Low Profile PCI add-in boards, Elan has created the P312. This model, from the P-Series range, features a Compact Flash Type II ejector and a circuit board that conforms to the MD1 profile specification. It will allow you to use any Compact Flash card such as IBM MicroDrives, Bluetooth cards, WLAN 802.11b cards, data acquisition cards, pager cards, GPS cards etc.
-
product
Optical Camera Trigger
The Optical Camera Trigger is an optical sensor that detects pulsed light sources and generates outputs to trigger a camera. The front aperture of the Optical Trigger must be directed at a light source that provides the necessary properties for trigger activation. (e.g. a laser flash lamp, a pick-off source from the main laser beam, or similar). The light source may be a direct or indirect pulsed waveform.
-
product
Electronic Inspection Systems
Intego's knowhow even makes it possible to identify challenging defects that may be located under the surface. One system is the inspection of chips by means of lock-in thermography, which visually represents the IR radiation intensity signal of electronics. Special lasers and flash lamps generate a very short heat impulse (10 ms) on the chip, which generates a measurable heat flow. In most cases, a resolution of < 1 μm can be achieved.
-
product
Walk-In Xenon Lamp Weathering Test Chamber
Xenon is one of the noble gases and is a major component of arc lamps and flash lamp and it also has its importance in general anesthetics. One of the major applications of xenon lamp is that it can be used in research applications to simulate the sunlight.Weiber walk in xenon lamp chamber uses xenon lamp to simulate the whole sunlight spectrum that can produce many destructive effects on the products. This simulation environment provided in the chamber is used to test the resistance of various ...show more -
product
OES Spectrometers
OES Spectrometers (Optical Emission Spectrometers for OEMs) optimized for SEMICON applications including plasma monitoring/end-point detection and reflectometry (with the addition of a flash lamp). The OES-Star features unmatched throughput and SNR, spectral coverage and < 1 nm resolution). Our new OES Family, OES-Star, VS70-MC and InVizU all include our latest “Multi-Communications interface” electronics (MC= EtherCAT, Ethernet, USB-2). The Invizu integrates both a linear CMOS sensor for UV-VIS and a TE-Cooled INGAAS sensor, which extends the spectral coverage to 1700 nm.
-
product
UV-Vis & UV-Vis-NIR Systems
Our range of powerful and productive UV-Vis and UV-Vis-NIR molecular spectroscopy systems offers options for any optical application. The Cary 60 Spectrophotometer has a unique Xenon flash lamp to enable remote sampling, while the Cary 4000 allows you to measure highly turbid solutions without an integrating sphere. The Cary 8454 photodiode array captures the complete UV-Vis spectrum (190-1100nm) in less than one second.
-
product
Solar Simulator
Jiangsu Keyland Laser Technology Co., Ltd.
Features:- Beyond Class AAA performance- Stable continuous working- 8000 data collecting points- Durable flash lamp- Voice prompt- Measuring data export- Customizable for special panels
-
product
Solar Stimulators
Alpha-Omega Power Technologies, LLC.
Alpha-Omega Power Technologies (AOPT) has developed a line of pulsed concentrator photovoltaic (CPV) solar simulators based in its experience with pulsed high voltage flash lamp systems and its patented high speed, high power load.
-
product
Power Utility Industry
Major product types include:*Auxiliary and Tripping Relays*Test Blocks*Arc Flash Protection*Utility Grade Protection and Control Relays*Industrial Controls and Pilot Lamps*On Board Railway Relays, CB’s and Panel Meters
-
product
Fluorescence Spectrophotometry
Agilent’s fluorescence systems, built by a global leader in fluorescence technology and molecular spectroscopy, are used by labs all over the world. The unique Xenon flash lamp technology in our Cary Eclipse Spectrophotometer delivers superior flexibility and sensitivity, and is ideally suited for use with fiber optic technology and bio-sample analysis. The Cary Eclipse is a high-performance workhorse for your analytical needs, providing robust, consistent results in every application.
-
product
Lamp gauge
E27
Shenzhen Chuangxin Instruments Co., Ltd.
To check the maximum dimensions of the screw thread and dimension T1 minimum of caps on finished lamps shown on sheet 7004-2.
-
product
Flash Point
At which temperatures will your sample burn, ignite, or cause fire? How are your flammable liquids composed, and what are their properties? Volatility is directly related to a substance‘s flash point temperature (flammability). Anton Paar’s flash point testing equipment safely and easily determines the values you require for the processing, storage, transportation, and classification of dangerous liquids.
-
product
Led Lamps
The range of professional lamps signed HT, to facilitate your work and shed light on your results.
-
product
Flash Meters
SF 100
Flash meters for measurement of illuminance time response of rapid changing light sources (flashes, rotating beacons).
-
product
IEC60061-3 Lamp Gauge
Shenzhen Chuangxin Instruments Co., Ltd.
This Draught-proof is designed according to standard IEC60598. Applied to provide standard environment condition for lamps product temperature measurement. The draught-proof applicable under normal operation and is detected lamps temperature air convection under abnormal operation, to prevent the effects of air temperature and thermal radiation from the light source to the sample.
-
product
LED Goniophotometer for Lamps
880
Shenzhen Chuangxin Instruments Co., Ltd.
Be used to measure the luminous intensity distribution curve intensity data spread angle and equivalent luminous flux of luminaries. Computer controls the whole test process automatically with low cost and simple operations.
-
product
Arc Flash Analysis
ETAP Arc Flash Analysis allows you to identify and analyze high risk arc flash areas in your electrical system, and it also allows simulation of several different methods used by engineers to mitigate high incident energy.
-
product
Lamp Converters
PeakTech Prüf- und Messtechnik GmbH
This AC / AC voltage converter is particularly suitable for use with halogen indoor lights and other low-voltage light sources that require an AC voltage source for supply. There is a safe galvanic separation between mains and low voltage according to the isolating transformer standard. This pre-assembled AC / AC converter is equipped with an overtemperature switch that cannot be reset.
-
product
Flash Point Tester
Weshine Electric Manufacturing Co., Ltd
Closed flash point tester, when the test sample is used in a closed environment (such as transformer oil), to determine the closed flash point value of petroleum products. Use touch screen instead of keyboard operation, adopt foreign advanced technology, large LCD screen LCD full Chinese display man-machine dialogue interface, full screen touch key prompt input, convenient and fast, open, fuzzy control integrated software, modular structure, in line with national standards, the United States, EU and other standards.
-
product
Open Cup Flash Point Testers
Open cup flash point tester, Cleveland open cup flash point tester, automatic Cleveland open cup flash point tester, Automatic COC flash & fire point tester
-
product
Digital Lamp Cap Torsion Tester
CX-l338
Shenzhen Chuangxin Instruments Co., Ltd.
Torque Tester is a newly developed intelligent product with microprocessor built-in.
-
product
Arc Flash Monitoring
Arc fault protection for the fast clearance of arcing faults on BUS bars & within metal clad switchgear & associated cable boxes. The arc is detected using an optical sensor & the signal input to a protection device which alsomonitors the load current on the system.
-
product
UV Lamp Control Gear
UV Series
These are designed and manufactured to meet not only customers specifications, but also our own high standards of workmanship and performance.
-
product
Lamp Spot Type UV Curing System
AICURE UP50
Panasonic Industrial Devices Sales Company of America
Panasonic Lamp Spot Type UV Curing System
-
product
DC Power Source for Standard Lamp
DC502
DC502 is CONSTANT CURRENT DC POWER SUPPLY for standard lamp. Function and technical indexes are as follows: • output voltage 4 grades: 6V/12V/24V/50V • output current: DC 0~2.5A (adjustable) • Output current drift at full scale: ±0.05% reading value/10 mins • Monitor range of ampere meter: 0.0000A ~1.9500A, 1.950 A ~2.500A • Accuracy of ampere meter: ± (0.08% reading value + 0.02% full scale) • Max output power: 80W • Continuous working time: 8 hours • Work environment: Temperature 0℃ -25℃, humidity ≤ 85%R.H, supply source: AC220 ±10%, 50/60HZ • Holding conditions: -20~50℃ humidity < 75%R.H • Outside dimension (W×H×D): 333mm×114mm×307mm • Weight: about 8kg • Power: about 1000VA
-
product
Flash ISP Feature, GTE 10.00p
K8219A
The Flash ISP feature enables in-system programming that is usually executed through a flash player application that drives the MCU to execute the programming onto the flash device.
-
product
AC Flash Tester
THPG
Very Heavy Duty with high milliamp capacity for properly testing motors and windings.
-
product
Automatic Open Cup Flash Point Tester
HTYKS-H / 683
Wuhan Huatian Electric Power Automation Co., Ltd.
Used for determination of open flash point of petroleum products.
-
product
Flash Diffusivity Analyzers
DLF 2800
The Discovery Laser Flash DLF 2800 is an advanced freestanding instrument for the measurement of thermal diffusivity and specific heat capacity of materials from room temperature to 2800°C. The distinctive design incorporates a proprietary laser, laser optics, detector, and furnace technologies, and along with the unique six-position sample carousel, ensures unprecedented measurement accuracy and sample throughput. With the ability to operate in a variety of atmospheric conditions, including inert gas or under vacuum, the DLF 2800 can characterize a wide variety of materials, including polymers, ceramics, carbons, graphite, composites, glasses, metals, and alloys.
-
product
Flash Diffusivity Analyzers
The Light Flash technique provides information on a material’s ability to store and transfer heat through measurements of thermal diffusivity, thermal conductivity, and specific heat capacity. Thorough understanding of these properties is critical for any process or material which experiences a large or fast temperature gradient, or for which the tolerance for temperature change is exacting. Accurate values of these properties are essential for modeling and managing heat, whether the component o...show more