ORTEC
ORTEC is an industry leader in the design and manufacture of ionizing radiation detectors, nuclear instrumentation, analysis software, and integrated systems.
- 865-482-4411
- 865-483-0396
- ortec.info@ametek.com
- 801 South Illinois Avenue
Oak Ridge, TN 37830
United States
Filter Results By:
Products
Applications
-
product
Fast Timing Discriminators
Fast timing discriminators enable the counting of narrow pulses at very high counting rates, and/or precisely marking the arrival time of these same pulses. They are designed to achieve the best time resolution and the highest counting rates by operating on the fast-rising detector signal.
-
product
Hand-held Radioisotope Identification Device
RadEAGLET
Combining a large, high sensitivity crystal with a proven and tested intelligent algorithm, the RADEAGLET can quickly, accurately, and simultaneously detect and identify up to six isotopes, typically in under 30 seconds. The RADEAGLET performs well, even in complex shielded or masked scenarios. ANSI 42.34 compliant, the RADEAGLET offers a user-friendly interface that is intuitive, simple to navigate, provides visually clarity, and utilizes an extensive array of alarms. Supports NaI(Tl) and LaBr3(Ce) to optimize performance across multiple applications.
-
product
Preamplifiers
The primary function of a preamplifier is to extract the signal from the detector without significantly degrading the intrinsic signal-to noise ratio. Three basic types of preamplifiers are available: the current-sensitive preamplifier, the parasitic-capacitance preamplifier, and the charge-sensitive preamplifier. ORTEC manufactures a preamplifier to fit your detector, your application, and your budget.
-
product
Time to Amplitude Converters and Calibrator
A Time-to-Amplitude Converter (TAC) can achieve exceptional precision by using an analog technique to convert small time intervals to pulse amplitudes. When a timing application demands picosecond precision, a time-to-amplitude converter is a prime candidate. A time-to-amplitude converter is a productive solution for measurements less than 10 μs when time resolutions from 10 ps to 50 ns are required.
-
product
Alpha Spectroscopy
Alpha spectroscopy is used to identify and quantify radionuclides based on the alpha particles emitted in the decay process. Similar to Gamma Spectroscopy, energy spectra are generated with high precision detectors and electronics and analyzed with special software. Typically, samples are measured following chemical separation to isolate the radionuclides of concern due to the complexity associated with correcting for these interferences with spectrum analysis software as is common for many Gamma Spectroscopy measurements.
-
product
Amplifiers
The amplifier is one of the most important components in a pulse processing system for applications in counting, timing, or pulse amplitude (energy) spectroscopy, providing the pulse-shaping controls needed to optimize the performance of the analog electronics.
-
product
Alpha/Beta Counters
ORTEC offers a full suite of MANUAL alpha/beta counters incorporating either gas-flow proportional detector or dual-phosphor scintillation detector technologies. These manual, single detector systems are ideally suited for applications requiring long count times for a small number of samples.
-
product
Mobile Assay System
ISO-CART-85
Complete In-situ NDA Gamma-Ray Analysis Solutions for a Wide Variety of Samples including "Free-Release" Decommissioning WasteMeasures all common geometries: pipes, cylinders, floors, ceilings, walls, drums, boxes, and soilsEasy-roll cart for maneuvering over any surfaceWide selection of collimators and shields available for different measurement situationsContinuous height adjustment and variable tilt adjustmentISOTOPIC software, proven results on thousands of real-world samplesFactory pre-calibrated or calibrate with a single inexpensive mixed isotope point sourceFlexible reporting: measurement results can be reported in grams or activity (Bq or Ci)
-
-
product
Gross Gamma Screening System
The Gross Gamma Screening system is intended for the rapid screening of urine samples for the presence of elevated radioactivity in a post-radiological event scenario. This system allows up to eight urine samples to be counted simultaneously in discretely shielded 3” x 3” NaI Well radiation detectors to quickly identify elevated radioactivity from personnel in the exposed population. This screening process provides critical information to Emergency Response Agencies and is accomplished with minimal operator training.
-
product
Health Physics Systems
Detection and quantification of radioactive material within the body is a key factor in determining internal personnel contamination and dose assessment. These measurements can be made on body fluid samples using lab instrumentation or through direct measurement of personnel. The measurement of body fluids is generally less attractive due to the bio-hazards and lack of immediate results unless non-gamma emitting nuclide measurements are required. The direct measurement of personnel for gamma emitting radioactive material provides rapid results, can determine where the material may be located within the body, and does not require mobility of the material through body fluids for detection.
-
product
Gross Alpha/Beta Measurement Systems
Gross alpha/beta measurement is one of the simplest radioanalytical procedures which are applied widely as a screening technique in the field of radioecology, environmental monitoring and industrial applications. This procedure has been developed to determine whether radionuclide specific analysis is required to further characterize the water. Regular measurements of gross alpha and gross beta activity in water may be invaluable for early detection of radioactive contamination and indicate the need for supplemental data on concentrations of more hazardous radionuclides.
-
product
Food Monitoring Systems
Is a system of repeated examination, measurement and evaluation of levels of undesirable substances, such as plant protection products, heavy metals and other contaminants, in and on food.
-
product
Chemical Weapons Identification Systems
Portable Isotopic Neutron Spectroscopy (PINS) Systems have been deployed world-wide; increasingly, being deployed as part of national counter-terrorist efforts. PINS provides a non-contact and non-destructive means of identifying the CHEMICAL contents of "suspect" packages.
-
product
Custom Systems
ORTEC strives to meet your measurement needs in every aspect. If one of our standard solutions is not the answer, we have the expertise, equipment, and commitment to design and develop robust solutions that satisfy your particular application requirements.
Parent
-
Ametek Materials Analysis Division
The AMETEK Materials Analysis Division´s goal is to be the recognized market leading provider of world-class analytical systems, nuclear instrumentation and digital imaging solutions.
Siblings
-
Ametek Scientific Instruments
AMETEK Scientific Instruments has been recognized as a global leader in the design and manufacture of instrumentation for scientific research, particularly in the field of electrochemistry and weak AC signal recovery.
Siblings
-
SPECTRO Analytical Instruments GmbH
Elemental analysis is continuing to develop at a fast pace worldwide with the need for ultimate precision, complex system requirements, and expanding fields of applications for even routine operations. SPECTRO leads the progress advancements in this field by providing new solutions and continuous innovations.
Siblings
-
Vision Research Inc.
Vision Research is the manufacturer of the phantom cameras and that their parent company is Ametek.
Siblings
-
Amptek Inc.
A high technology company and a recognized world leader in the design and manufacture of state-of-the-art nuclear instrumentation for the satellite, x-ray and gamma ray detection, laboratory, analytical, and portable instrumentation industries.
Siblings
-
CAMECA
The CAMECA instruments provide elemental and isotopic composition data from micron down to sub-nanometer scale and equip the most prestigious government and university labs as well as leading high tech industrial companies around the world.
Siblings
-
EDAX
EDAX is now combined with Gatan to develop new approaches to uncover insights and explore the boundaries of your transmission and scanning electron microscopy (TEM and SEM) research. Under the Gatan name, customers will receive reliable, cutting-edge products of the highest quality while maintaining the responsive customer care that you expect.
